Toyota hiace – timing belt light reset

To reset the timing belt indicator without Multi Information Screen (2013 on), proceed as follows:

Turn on the ignition.
Adjust the display so that it is showing the TRIP B reading. (See Diagrams)
Turn off the ignition.
Press and hold the trip meter button and turn on the ignition.
Continue to hold the trip meter button for 5 seconds or more ensuring that the timing belt warning light is flashing.
Release the trip meter button then within 5 seconds press it once.
You now have 5 seconds to select the interval to the next timing belt change. turn the trip meter button to advance through the interval options.
Note: the interval options will be a two digit number representing the kilometres multiplied by 10,000 eg: 15 = 150,000 Km’s
Or if not changing the interval hold the trip meter button for 5 seconds or more.
The display returns to the Odometer reading and the Timing Belt light will turn off
To reset the Timing Belt reminder message without the Multi Information Screen.

Switch the ignition ON and set the TRIP meter RESET knob (located on the lower right hand side of the cluster) to display the Odometer reading (not the trip meter reading) and then turn the ignition OFF.
Press and hold the TRIP meter RESET knob and turn the ignition ON.
Press and hold the TRIP meter RESET knob for a further 5 seconds, release it and then hold it in again within 5 seconds.
Enter into the SETTING MODE and change to T-BELT DISPLAY MODE.
Press and hold the TRIP meter RESET knob for a further 5 seconds.
The display now changes to TRIP B and the warning light turns off indicating reset procedure is complete.
Release the knob and turn ignition to OFF.

Timing belt light reset kun16 hilux

Have you ever done the job on the car and realised where do i find the information to do the simple reset for a light?

How the TBELT light works

The TBelt light on the KUN16 Toyota, Hilux become activated at 150,000kms there is two different dash board models, the standard and the large lcd display, listed below is the reset procedure to cancel the tbelt light after the timing belt job has been done. Read More